Tuesday, March 11, 2008
RepRap Segment Pausing Fix
I’ve been working a lot on the RepRap code lately and I recently got it to the point where segment pausing is drastically reduced. This RepRap is driven with Arduino based electronics running a GCode interpreter firmware. Woot!
Segment Pausing Fix from Zach 'Iowa' Hoeken on Vimeo.
Update: here's a video from Vik showing the current segment pausing with the PIC based firmware.
RepRap Deposition Showing Pauses Between Segments from Vik Olliver on Vimeo.
Segment Pausing Fix from Zach 'Iowa' Hoeken on Vimeo.
Update: here's a video from Vik showing the current segment pausing with the PIC based firmware.
RepRap Deposition Showing Pauses Between Segments from Vik Olliver on Vimeo.
Comments:
<< Home
Looks great, Zach! Is it really as loud as it sounds in the clip or does your videocam have a sensitive microphone like my camera does?
no, its not very loud. my camera just really picks up the vibration noise.
plus i had the lamp and a board leaning up against the machine which caused extra vibrations.
plus i had the lamp and a board leaning up against the machine which caused extra vibrations.
Zach, try wrapping duct tape around one of the threaded bracing rods where they cross. This cuts down a lot of vibration.
Vik :v)
Post a Comment
Vik :v)
<< Home
