Monday, November 24, 2025
V0.05 Parallelogram Axis Driver Final Assembly Photos
Carrying on from a couple of posts back, here are the remaining stages of assembly for the RepRapMicron V0.05 Axis Driver.
The things not obvious from the photos are:
- The red Flexure Coupling on the motor is in a separate OpenSCAD file.
- You can use different height NEMA17 Plates to match the length of your motor's shaft.
- Adjust the position of the pair of locknuts so that the base of the Drive Screw goes into the hexagonal socket on the Coupling.
- Very lightly oil the drilled-out M3 nut bearings, the M3 x 50mm Drive Screw, and its washers.
Pipe up if I've missed anything.
Labels: driver, Pantograph, reprapmicron
