Monday, January 21, 2008


In stereo - another opto bracket

Following in Ed's footsteps, I've run off a copy of the opto bracket in PLA. The build time was 51 minutes, extruding at just under 140C. Looks good from here.

Vik :v)

Damn! So when will you have printed a full set of parts for another Darwin? It sure looks like you're getting there in a hurry. :-0
Yup. Just did another corner bracket. A few minor tweaks and we're doing one in just under 7 hours. The quality is sloping off a little bit at that point though. I wouldn't want to push it much further.

So I now have 4 RepRap'd corner brackets. Hmm, maybe a photo of my haul for the blog?

Vik :v)
Yupyup! :-)
Post a Comment

<< Home

This page is powered by Blogger. Isn't yours?

Subscribe to
Posts [Atom]