Thursday, May 11, 2006

 

The Half-tooth clicks!


Now to get to the problem of flipping the half tooth to make a full one and then creating a full gear outline by rotating the tooth around the gear centre. That should be no big deal.

After that I'll tackle the problem of meshing two of these bad boys. That might be a bigger deal. Stand by for some of my famous stupid questions. :-s

Okay, there's your full tooth. Now I've got to approximate a radial connect on the surfaces on top of the tooth and in the gap between teeth and I've pretty much got it.

Comments: Post a Comment

<< Home

This page is powered by Blogger. Isn't yours?

Subscribe to
Posts [Atom]