Monday, May 28, 2007
PLA Darwin Parts From Zaphod
I've run off a couple of PCB clips and a couple of brackets from PLA. You can see the stringing on the X constraint bracket - it looks like it as been enveloped by a spider. The thread can easily be picked off with a sharp point, fortunately.
The blob on top of the constraint bracket is where the software crashed. Fortunately it waited for the last layer...
Vik :v)
The blob on top of the constraint bracket is where the software crashed. Fortunately it waited for the last layer...
Vik :v)
Comments:
<< Home
Nice. The crosshatching gives it a sort of crystalline look. Like something out of the Fortress of Solitude.
Excellent photo :)
How long does it take to print these parts? Can they be used to replace some of you Darwin machine?
It should be displayed on RepRap website to show people a result of replication :)
How long does it take to print these parts? Can they be used to replace some of you Darwin machine?
It should be displayed on RepRap website to show people a result of replication :)
Smaller parts take about 20-30 minutes, the larger one about 3 hours I think.
I plan to use these arts in Darwin to see how they last compared to the ABS and CAPA parts.
Vik :v)
Post a Comment
I plan to use these arts in Darwin to see how they last compared to the ABS and CAPA parts.
Vik :v)
<< Home
