Wednesday, November 26, 2008

 

Heating the print surface: doing the numbers


Scaling up Metalab's heated printing surface... do you want to know more?

Comments:
Does the heater need to be on for the whole build ?

or just the raft and the first few skeins ?
 
Another obvious step is to break your bed up into smaller zones and only heat the area you will be printing on.
 
Tigger: "Does the heater need to be on for the whole build ?"

Haven't tried it yet, so I don't know. Marius is the person to ask about that.

Briand: "Another obvious step is to break your bed up into smaller zones and only heat the area you will be printing on."

Indeed. Sounds like a much more complicated design and control scheme to me, though.
 
hi friends you can find more about heating services on Central Heating System

Heatingcare is a trusted name in central heating system, installation, repair and service of gas central heating boilers. Whether you need installation of central heating system or Worcester Bosch boilers or combi boilers,our qualified engineers will take care of any heating problems.
 
Post a Comment

<< Home

This page is powered by Blogger. Isn't yours?

Subscribe to
Posts [Atom]

View mobile version