Blog for the RepRap project at www.reprap.org - a project to create an open-source self-copying 3D printer. To get all the early posts on this blog with all the images as a single PDF visit this page.
Heatingcare is a trusted name in central heating system, installation, repair and service of gas central heating boilers. Whether you need installation of central heating system or Worcester Bosch boilers or combi boilers,our qualified engineers will take care of any heating problems.
Does the heater need to be on for the whole build ?
ReplyDeleteor just the raft and the first few skeins ?
Another obvious step is to break your bed up into smaller zones and only heat the area you will be printing on.
ReplyDeleteTigger: "Does the heater need to be on for the whole build ?"
ReplyDeleteHaven't tried it yet, so I don't know. Marius is the person to ask about that.
Briand: "Another obvious step is to break your bed up into smaller zones and only heat the area you will be printing on."
Indeed. Sounds like a much more complicated design and control scheme to me, though.
hi friends you can find more about heating services on Central Heating System
ReplyDeleteHeatingcare is a trusted name in central heating system, installation, repair and service of gas central heating boilers. Whether you need installation of central heating system or Worcester Bosch boilers or combi boilers,our qualified engineers will take care of any heating problems.