V0.05 Parallelogram Axis Driver Final Assembly Photos

Carrying on from a couple of posts back, here are the remaining stages of assembly for the RepRapMicron V0.05 Axis Driver.

The things not obvious from the photos are:

• The red Flexure Coupling on the motor is in a separate OpenSCAD file.
• You can use different height NEMA17 Plates to match the length of your motor's shaft.
• Adjust the position of the pair of locknuts so that the base of the Drive Screw goes into the hexagonal socket on the Coupling. 
• Very lightly oil the drilled-out M3 nut bearings, the M3 x 50mm Drive Screw, and its washers. 

Pipe up if I've missed anything.