Blog for the RepRap project at www.reprap.org - a project to create an open-source self-copying 3D printer. To get all the early posts on this blog with all the images as a single PDF visit this page.
Pages
▼
Monday, January 21, 2008
In stereo - another opto bracket
Following in Ed's footsteps, I've run off a copy of the opto bracket in PLA. The build time was 51 minutes, extruding at just under 140C. Looks good from here.
Yup. Just did another corner bracket. A few minor tweaks and we're doing one in just under 7 hours. The quality is sloping off a little bit at that point though. I wouldn't want to push it much further.
So I now have 4 RepRap'd corner brackets. Hmm, maybe a photo of my haul for the blog?
Damn! So when will you have printed a full set of parts for another Darwin? It sure looks like you're getting there in a hurry. :-0
ReplyDeleteYup. Just did another corner bracket. A few minor tweaks and we're doing one in just under 7 hours. The quality is sloping off a little bit at that point though. I wouldn't want to push it much further.
ReplyDeleteSo I now have 4 RepRap'd corner brackets. Hmm, maybe a photo of my haul for the blog?
Vik :v)
Yupyup! :-)
ReplyDelete