tag:blogger.com,1999:blog-12223283.post6557472337847794464..comments2009-03-02T18:40:29.418ZAdrian Bowyerhttp://www.blogger.com/profile/17595509188999219420noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-12223283.post-40299330369057837892008-09-30T17:44:47.899+01:002008-09-30T17:44:47.899+01:00That's great vik!Demented Chihuahuahttp://www.blogger.com/profile/01715419261430119998noreply@blogger.comtag:blogger.com,1999:blog-12223283.post-63777867040051863052008-09-30T12:25:37.864+01:002008-09-30T12:25:37.864+01:00Yey, magical reprapped cats! I wonder if it's possible to have a support-material mode that consists of the nozzle half-closed, or the motor running very slowly with the nozzle open.James Mastros (theorbtwo)http://www.blogger.com/profile/12254823132381511712noreply@blogger.comtag:blogger.com,1999:blog-12223283.post-24385144617346978162008-09-30T12:19:41.876+01:002008-09-30T12:19:41.876+01:00The feet were indeed "down" and the chin was hanging in the air. Fortunately strands of plastic magically supported everything in the right place by total fluke!<BR/><BR/>Vik :v)Vik Olliverhttp://www.blogger.com/profile/14574212494833831824noreply@blogger.comtag:blogger.com,1999:blog-12223283.post-3774762030895350122008-09-30T07:56:03.611+01:002008-09-30T07:56:03.611+01:00I'm having some difficulty understanding how this could possibly print... were the cat's feet not "down" during extrusion? If they were, doesn't that mean that the chin was hanging in midair until it was connected to the neck? If it was extruded with down being the left in your photo, then it wasn't overhang at all.James Mastros (theorbtwo)http://www.blogger.com/profile/12254823132381511712noreply@blogger.com