tag:blogger.com,1999:blog-12223283.post5901048802046435349..comments2009-02-19T18:03:35.929ZAdrian Bowyerhttp://www.blogger.com/profile/17595509188999219420noreply@blogger.comBlogger6125tag:blogger.com,1999:blog-12223283.post-21607960214843132482008-07-31T21:43:42.275+01:002008-07-31T21:43:42.275+01:00What I want to know is, are there instructions available on how to assemble the parts from the lasercutting into a reprap? Plans are all well and good, but it might be pretty painful to trial-and-error the assembly.Ralithhttp://www.blogger.com/profile/16182722066065242780noreply@blogger.comtag:blogger.com,1999:blog-12223283.post-23564756853333205952008-07-27T04:59:57.814+01:002008-07-27T04:59:57.814+01:00Will it work with wood?Gene Hackerhttp://www.blogger.com/profile/08102631233498143328noreply@blogger.comtag:blogger.com,1999:blog-12223283.post-81621563461308416122008-07-24T13:27:17.781+01:002008-07-24T13:27:17.781+01:00Dead sexy... d'you do trade ins?eDhttp://www.blogger.com/profile/16037344080711177729noreply@blogger.comtag:blogger.com,1999:blog-12223283.post-81068810462771352692008-07-22T21:18:29.221+01:002008-07-22T21:18:29.221+01:00I just noticed something about this. Had to zoom in on the image to see it. With the clear acrylic, you can see where the filament is in the extruder. Very handy for feeding in new pieces.Steve DeGroofhttp://www.blogger.com/profile/14997304093518156268noreply@blogger.comtag:blogger.com,1999:blog-12223283.post-10641683867062118462008-07-22T17:51:28.791+01:002008-07-22T17:51:28.791+01:00Megacool! :-DForrest Higgshttp://www.blogger.com/profile/17208965471464716174noreply@blogger.comtag:blogger.com,1999:blog-12223283.post-47471101868109642312008-07-22T16:32:31.604+01:002008-07-22T16:32:31.604+01:00Very nice. I like the clear acrylic. I see quite a few refinements on this: belt tensioner, new extruder, floating bed.Steve DeGroofhttp://www.blogger.com/profile/14997304093518156268noreply@blogger.com