tag:blogger.com,1999:blog-12223283.post5263289246339905555..comments2009-02-24T00:42:29.848ZAdrian Bowyerhttp://www.blogger.com/profile/17595509188999219420noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-12223283.post-20010731356154006702007-03-07T01:06:40.257Z2007-03-07T01:06:40.257ZTwo heads are better than one! Hey, is this another slogan for Reprap?<BR/>And nice going Vik.Bart Andersonhttp://www.blogger.com/profile/17154812587347430401noreply@blogger.comtag:blogger.com,1999:blog-12223283.post-30419006132354112742007-03-06T18:07:46.512Z2007-03-06T18:07:46.512ZPlaas - I think my nozzle splits are due to bad workmanship. One of your nozzles might fix that :)<BR/><BR/>Unlike the previous nozzle which split, this one just has a couple of pinholes where my filing got too close to my drilling.<BR/><BR/>eD - Go for it.<BR/><BR/>Vik :v)Vik Olliverhttp://www.blogger.com/profile/14574212494833831824noreply@blogger.comtag:blogger.com,1999:blog-12223283.post-11348935017395215892007-03-06T14:45:52.376Z2007-03-06T14:45:52.376ZCongrats Vik!! I'll put that into my seminar tomorrow if that's ok with you...eDhttp://www.blogger.com/profile/16037344080711177729noreply@blogger.comtag:blogger.com,1999:blog-12223283.post-91271313432798919232007-03-06T13:49:54.879Z2007-03-06T13:49:54.879ZGreat work, Vik! Yet another milestone! Shall I make up one of my copper tube extruder barrels for you so that you can stop worrying about nozzle splits? :-)plaasjaapiehttp://www.blogger.com/profile/17208965471464716174noreply@blogger.com